Dpr Signal; Antenna Tuner Control Interface - Quectel EM06 Series Manual

WAKE_ON_WAN#

3.10.4. DPR Signal

The module provides a DPR (Dynamic Power Reduction) signal for body SAR (Specific Absorption Rate)
detection. The signal is sent by a host system proximity sensor to the module to provide an input trigger
which will reduce the output power in the radio transmission.
Table 17: Function of the DPR Signal
DPR Level
High/Floating
Low
NOTE
Please refer to document [2] for more details about AT+QCFG="sarcfg" command.

3.11. Antenna Tuner Control Interface*

ANTCTL [0:3] signals are used for antenna tuner control and should be routed to an appropriate antenna
control circuitry.
More details about the interface will be added in the future version(s) of the document.
EM06_Series_Hardware_Design
VCC from the Host
Module
Figure 24: Reference Design of WAKE_ON_WAN#
Function
Max transmitting power will NOT back off
Max transmitting power will back off by executing AT+QCFG="sarcfg" command
10K
LTE-A Module Series
EM06 Series Hardware Design
Host
40 / 69