Operating Modes - Quectel EM06 Series Manual

74 VCC
75 CONFIG_2
⚫
NOTE
Please keep all NC, reserved and unused pins unconnected.

3.3. Operating Modes

The table below summarizes different operating modes of EM06 series.
Table 5: Overview of Operating Modes
Mode Details
Idle
Normal
Operating mode
Talk/Data
Minimum The AT+CFUN=0 command can enable the minimum functionality mode without
Functionality removing the power supply. In this mode, both the RF function and (U)SIM card are
Mode invalid.
Executing the AT+CFUN=4 command or driving the W_DISABLE1# pin to low level
Airplane Mode
can enable the airplane mode. In this case, the RF function is invalid.
The module keeps receiving paging messages, SMS, voice calls and TCP/UDP data
Sleep Mode
from the network, its current consumption reduced to the minimal level.
The module's power supply is cut off by its power management unit, its software
Power Down
being inactive and USB interface inaccessible while the operating voltage (connected
Mode
to VCC) remains applied.
⚫
NOTE
See document [2] for more details about AT+CFUN command.
EM06_Series_Hardware_Design
PI Power supply
Not connected internally
The module has registered on network and is ready to send and
receive data, its software being active.
The module is connected to network, its power consumption decided
by network settings and data transfer rates.
LTE-A Module Series
EM06 Series Hardware Design
Vmin = 3.135 V
Vnorm = 3.7 V
Vmax = 4.4 V
22 / 69