Port Image And Led Indicators - Ruijie RG-RSR10-02E Series Hardware Installation And Reference Manual

Table 1-8 Crossover Cable Pinouts
RJ45 Pin #
End 1
1
2
3
6
GE Ports

Port Image and LED Indicators

The following figure shows the fixed GE ports and its corresponding Link/ACT LED indicators.
Figure 1-9 GE Ports and Corresponding LED Indicators
For descriptions of GE port Link/ACT LED indicators, see the "LED Indicators" section.
An RSR10-02E series router provides two fixed 10/100/1000 Mbps Ethernet ports. The copper port uses an RJ-45
connector.
Features
The following table describes the basic features of the GE ports.
Table 1-9 Specifications of the GE ports
Parameter Description
Two 10/100/1000Base-T/1000Base-TX interfaces
Interface
Interface
IEEE Std 802.3-2008
standard
Cables
10/100/1000Base-T uses the Category 5e UTP or STP with the maximum transmission distance of 100 meters.
Straight-through cable: All wire pairs are in the same order on each end of the RJ45 cable. The straight-through cable is
used to connect a terminal device such as a PC or router to a hub or LAN switch.
Signal Color
TX+ White-green
TX- Green
RX+ White-orange
RX- Orange
RJ45 Pin #
End 2
1
2
3
6
Signal Color
TX+ White-orange
TX- Orange
RX+ White-green
RX- Green