Table of Contents
Advertisement
1.
Wear an ESD wrist strap and make sure the strap makes good skin contact and is reliably
grounded.
2.
Power off the device.
3.
Remove the access panel. For more information, see
4.
Install a DIMM:
a. Identify the location of the DIMM slot and open the DIMM slot latches.
b. Align the notch on the DIMM with the connector key in the DIMM slot and press the DIMM
into the socket until the latches lock the DIMM in place.
Figure7-13 Installing a DIMM
5.
Install the access panel. For more information, see
Installing an M.2 SSD drive
IMPORTANT:
• For system identification, use M.2 SSD drives recommended by H3C.
• The M.2 SSD drive screw is shipped with the document bag for the chassis. Before installing an
M.2 SSD drive, keep the screw secure.
The device supports M.2 SSD drives with dimensions of 22 × 80 mm (0.87 × 3.15 in) and M.2 SSD
drives with dimensions of 22 × 60 mm (0.87 × 2.36 in). To install an M.2 SSD drive with dimensions
of 22 × 60 mm (0.87 × 2.36 in), adjust the stud location in the system board. The following
procedure installs an M.2 SSD drive with dimensions of 22 × 80 mm (0.87 × 3.15 in).
To install an M.2 SSD drive:
1.
Wear an ESD wrist strap and make sure the strap makes good skin contact and is reliably
grounded.
2.
Power off the device.
3.
Remove the access panel. For more information, see
"Installing a storage
"Installing a storage
"Installing a storage
18
controller."
controller."
controller."
Advertisement
Table of Contents
