Recalling Setups/Preprogrammed Test Conditions - QuadTech Guardian 2500 Series Instruction Manual

Condensed Operating Instructions (continued)

Recalling Setups/Preprogrammed Test Conditions

1. Press the TEST NUMBER key to sequence up through the test setups, those with no
program stored will show the message "No Test Programmed". Continue to press the key
repeatedly to select any setup desired (user test 1-25, or sequence S1-S9). Typical display
below shows setup #1 programmed for AC Hipot at 500 volts, high current limit of 15 mA
and test time of 7 seconds. Note the message "Idle" in the upper right display, this area
always indicates the instrument status. (Pressing the
sequence through the test setups, up or down)
2. Once the desired test # has been selected (remains displayed) it is possible to view all test
parameters by pressing the
Press arrow for
VIEW mode
Press arrow to
view next parameter
Press arrow to
view next parameter
Page 20 of 20
1 AC:0.500KV
Hi:15.00mA
left/right arrow keys as follows:
1 AC:0.500KV
Hi:15.00mA
1
Mode: AC Total Current
1
Volt: 0.500KV
1
Hi Limit: 15.000mA
Press to continue VIEW or
Press to reverse direction
up/down arrow key will also
Idle
7.0sec
Idle
7.0sec
View
View
View