Test To View; Perform Calibration - QuadTech Guardian 2500 Series Instruction Manual

8. Tests To View
The following selection determines which tests in memory, when selected by test number, are
displayed in View mode. Single step are 1 through 25 and sequence are S1 through S9.
Press the UTILITY key and
If Enhanced Features is set for On, press
If Enhanced Features is set for Off, press
right arrow key to select Tests to View
Press up/down arrow keys to select Tests To View, All Tests (1-25, and S1 - S9),
Only Single Step (1 - 25), Only Sequence (S1 - S9).
Press the UTILITY key to exit or move to other Enhanced Features with the
arrow key

9. Perform Calibration

This selection indicates the instruments expected calibration date and can be used to enter a
calibration routine. This procedure should only be used by qualified calibration personnel and
does require proper calibration equipment and password entry.
Calibration section of this manual for addition information.
Page 62 of 62
right arrow key to select Enhanced Features.
Tests To View
All Tests
Tests To View
Only Sequence
Tests To View
Only Single Step
right arrow key to select Tests to View.
up/down arrow key to select On and press
Util
Util
Util
Refer to the Service and
Operation/Programming
right