Table of Contents
Advertisement
Condensed Operating Instructions (continued)
Return the display to Idle mode (upper right) and the test # desired (upper left) before
proceeding.
Modifying/Programming Test Conditions
1. Press the TEST NUMBER key to sequence up through the test setups, selecting one for
change or one not presently programmed, as noted by the message "No Test Programmed".
Continue to press the key repeatedly to select any setup desired (user test 1-25, or sequence
S1-S9). Typical display below shows setup #1 programmed for AC Hipot at 500 volts, high
current limit of 15 mA and test time of 7 seconds. Note the message "Idle" in the upper right
display, this area always indicates the instrument status. (Pressing the
key will also sequence through the test setups, up or down)
2. Once the desired test # has been selected (remains displayed), to change test conditions
proceed as follows:
Table of Programmable Test Conditions
For the Guardian Models 2510, 2520, 2530
Programmable
Parameters
Mode
Voltage
Hi Limit
Lo Limit
Arc Limit
Ramp Time
Hi Limit Ramp
Lo Limit Ramp
Dwell Time
Test Time
Fall Time
Frequency
Gnd Continuity
1 AC:0.500KV
Hi:15.00mA
2510
2520
2530
2520
2530
2530
AC
DC
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
Idle
7.0sec
IR
X
X
X
X
X
X
X
X
X
X
X
up/down arrow
Page 21 of 21
Advertisement
Table of Contents
