Utility Functions; General - QuadTech Guardian 2500 Series Instruction Manual

2.4

Utility Functions

2.4.1 General

The Utility functions allow the user to set the Measure Offset function for a currently selected
test and set other conditions that affect all tests. When the UTILITY key is pressed the first
function, Meas Offset, is displayed and the test number to which this applies is shown in the
upper left display. Other functions are accessed by pressing the
Table of Programmable Parameters For Utility Functions
Programmable
Functions
Measure Offset
Keypad Lockout
Test Locations
Beep on Key Hit
RS232 Interface
IEEE-488 Interface
(optional)
Enhanced Features
applies only to a sequence test (S1-S9) -
applies only to an IR test -
applies only to a sequence test (S1-S9) -
does not apply to the 2510 -
Page 50 of 50
Settings
On, Off,
Press Start-Get Offset
Lock Password, Off
Lock Cycle Tests
Hide Disabled Tests
Show All Tests
Soft, Off, Loud
On, Off
9600, 19200, Disable
1 to 16
On, Off
right arrow key.
This function applies to a single test,
other functions apply to all tests
Note: Bold denotes normal default
conditions when shipped from
factory.
Programmable
Functions With (On)
Test Low Limit
Delay Time
Continue Voltage On
Fail
Continue Steps On Fail
Stop Test On Pass
Step And Increment
Clear All Tests
Tests To View
Perform Calibration
Ground Fault Stop
Arc Pulse Width
Adaptive DC Ramp
Autoranging
Operation/Programming
Settings
Continuous, End of
Test
Off, 0.1 to 999.9sec
On, Off
On, Off
On, Off
Off, On
No, Yes
All Tests
Only Single Step
Only Sequence
(Follow procedure as
indicated on display)
Off, On
Off-DUT Grounded
1 to 50µsec
Off, On
Full, None, Limited