QuadTech Guardian 2500 Series Instruction Manual page 70

Operator Help messages (continued)
Up, down, utility, and start keys are valid
Voltage changed to, correspond to meas param
>nnn.n
Instrument Error Messages
CALIBRATION MEASUREMENT, FAILED
CALIBRATION MEASUREMENT, TIMED OUT
CAN NOT BURN, CALIBRATION DATA
CONFIGURED REMOTE, HARDWARE NOT DETECTED
DAC OVER RANGE
EEPROM CALIBRATION, DEFAULTS BEING SET
EEPROM PERSONALITY, DEFAULT BEING SET
EEPROM PERSONALITY, BEING SET FROM REMOTE
EEPROM REMOTE OPTIONS, DEFAULTS BEING SET
EEPROM TEST/STEP DATA, DEFAULTS BEING SET
EEPROM MISC DATA, DEFAULTS BEING SET
EEPROM LOCKOUT STATE, DEFAULT BEING SET
ERROR IN CALCULATION
ERROR IN, CALIBRATION
ERROR NOT FOUND
FATAL EEPROM PERSONALITY, CANNOT BE INITIALIZED
FATAL UNABLE TO WRITE, EEPROM TEST CHECKSUM
FATAL UNABLE TO WRITE, EEPROM CURRENT TEST/STEP
FATAL UNABLE TO WRITE, EEPROM TEST PARAMETER
FATAL INVALID, GUARDIAN 2500 UNIT
FATAL EEPROM CAL DATA, CANNOT BE INITIALIZED
FATAL EEPROM REM OPTIONS, CANNOT BE INITIALIZED
FATAL EEPROM TEST/STEP, CANNOT BE INITIALIZED
FATAL EEPROM MISC DATA, CANNOT BE INITIALIZED
FATAL NO DATA DURING, MEASUREMENT
FATAL INVALID, HANDLER RETURN
GENERAL INTERNAL ERROR
Page 70 of 70
Measurement exceeded the limits of the unit to
make an accurate measurement. This may be seen
during RAMP time if the DUT is a very low
resistance and the programmed voltage cannot be
achieved. It is displayed for IR measurements
when the DUT has substantial capacitance,
preventing the unit from autoranging up to a
sensitivity at which the resistance can be measured
accurately
Error in data processing
Operation/Programming