Stop Test On Pass - QuadTech Guardian 2500 Series Instruction Manual

Press the UTILITY key to exit or move to other Enhanced Features with the
arrow key.

5. Stop Test On Pass

This selection determines if the unit will stop testing during an insulation resistance (IR)
measurement once the value exceeds the low limit, which would meet the requirements for a
Pass. This feature only applicable in IR mode.
Press the UTILITY key and
If Enhanced Features is set for On, press
If Enhanced Features is set for Off, press
Press right arrow key to select Stop Test On Pass.
Press up/down arrow keys to select Stop Test On Pass, On or Off
Press the UTILITY key to exit or move to other Enhanced Features with the
arrow key.
Operation/Programming
Cont Steps On Fail
On
Cont Steps On Fail
Off
right arrow key to select Enhanced Features.
Stop Test On Pass
On
Stop Test On Pass
Off
Util
Util
right arrow key to select Stop Test On Pass.
up/down arrow key to select On and
Util
Util
right
right
Page 59 of 59