QuadTech Guardian 2500 Series Instruction Manual page 26

Condensed Operating Instructions (continued)
1 0.325KV
AC Tot * 0.005mA
PASS
3. Test Results Display with Single Test Selected (1 – 25)
If limits are not exceeded during the test the instrument will cycle through the complete test
and the Pass indicator (green) will light. The unit is ready for another test.
If limits are exceeded during the test the instrument's high voltage will shut down, the
display will indicate the failed limit and an audible alarm will sound (only if buzzer is
enabled, see Utility function, paragraph 3.4). Press the STOP button two times, one to stop
the buzzer (if enabled) and again to reset before another test can be initiated.
One of the following "Display messages" will be shown (upper right of the display)
Display
Pass
Lo Ramp
Hi Ramp
Lo Fail
Hi Fail
Arc Fail
GC Fail
An asterisk following the parameter as illustrated in the measurement display above
(AC Tot *) indicates that the Measure Offset is selected for ON. No asterisk will be
shown in the measurement result with Measure Offset to OFF. Refer to Measure
Offset, paragraph 2.4.2
An asterisk following a Pass message as illustrated in the measurement display above
(Pass*) indicates a conditional pass. A conditional pass can occur when the enhanced
feature "Continue Voltage On Fail" is enabled. The asterisk indicates that the device
failed at some point during the test but was passing at the end of the test. This would
only be seen with "Continue Voltage On Fail" enabled. Refer to Continue Voltage On
Fail, paragraph 2.4.9, step 3.
Page 26 of 26
Pass*
0.0s
Test Condition
Measurement falls within set limits
Measurement was below low limit during ramp time
Measurement exceeded high limit during ramp time
Measurement was below low limit during test time
Measurement exceeded high limit during test time
Measurement exceeded arc limit
Measurement exceeded ground continuity high limit
1 0.325KV
AC Tot * 0.005mA
FAIL
NOTE
Hi Fail
3.5s