Ingeteam INGECON SUN STORAGE 1Play Installation And Operation Manual page 6

Ingeteam
INFO
These instructions must be easily accessible close to the unit and located within reach of all users.
Before installation and start-up, please read these safety instructions and warnings carefully as well as all the
warning notices located on the unit. Ensure that all the warnings signs are perfectly legible and that those which
are damaged or have disappeared are restored.
Protection against direct contact is by means of the enclosure.
The unit has been tested according to the applicable regulations to comply with the safety requirements, the
values for insulation clearances and leakage paths for the voltages used.
Potential hazards for people
DANGER
Electric shock.
The equipment may remain charged after disconnecting the PV array, grid power and auxiliary power.
The equipment may remain charged after disconnecting the storage system, grid power and auxiliary power.
Carefully follow the mandatory steps in the manual for removing the voltage.
Explosion.
There is a very low risk of explosion in very specific cases of malfunction.
The casing will protect people and property from the explosion only if it is correctly closed.
Crushing and joint injuries.
Always follow the indications in the manual on moving and placing the unit.
The weight of this unit can cause serious injury and even death if not handled correctly.
High temperature.
The flow of outlet air can reach high temperatures which can cause injury to anybody exposed to it.
Potential hazards for the equipment
DANGER
Cooling.
The unit requires particle-free air flow while it is operating.
Keeping the unit in the upright position and the inlets free of obstacles is essential for this air flow to reach the
inside.
Do not touch boards or electronic components. The more sensitive components can be damaged or destroyed by
static electricity.
Do not disconnect or connect any terminal while the unit is operating. Disconnect and check for absence of
voltage first.
With the aim of avoiding premature wear of the screwed joints on the unit's housing panels, removal and
installation of the screws must be done manually.
6
Important Safety Instructions
ABH2015IQE01_ - Installation and Operation Manual