Connection Of The Storage System; Safety Instructions For Connecting The Storage System; Wiring Requirements For Connecting The Storage System; Use Of Ferrite Cores - Ingeteam INGECON SUN STORAGE 1Play Installation And Operation Manual

Hide thumbs Also See for INGECON SUN STORAGE 1Play:

Table of Contents

Connection of the storage system

8. Connection of the storage system

This chapter explains the requirements and process for connecting the storage system wiring to the unit. Read

carefully before starting the connection process.

CAUTION

Before you start to make the connections, make sure there is no voltage in the inverter. Verify that the AC

protection of the auxiliary genset and the DC protection of the storage system are open, as well as the PV array

and the consumption grid.

Do not switch on the power to the unit until you have successfully made the rest of the connections and the unit

is closed.

When carrying out the connections, respect the polarities marked on the electronic card. If the connection is

performed incorrectly the inverter could be damaged

Ingeteam accepts no liability for any damages caused by an incorrect connection.

The wiring gauge for connecting the storage system is specified in the following table:

Wiring gauge

Wiring diameter

Wiring stripping length (L*)

Two of the ferrite cores supplied must be used to connect the storage system. Turn each wire around twice, as

indicated in the following figure.

ABH2015IQE01_ - Installation and Operation Manual

INGECON SUN STORAGE 1Play

Up to 32 A

Up to 40 A

4 mm

6 mm

9 ~ 13 mm

18 mm

Ingeteam

Up to 50 A

10 mm

Table of Contents