Ingeteam INGECON SUN STORAGE 1Play Installation And Operation Manual page 50

Ingeteam
To connect the INGECON SUN EMS Board follow these steps:
1. Connect the EMS Board to connectors J11 and J12 of the control card as shown in the figure below.
2. If you wish to establish Wi-Fi communication with the router, you must install the Wi-Fi antenna and the
Reset button. Follow the instructions in section "16.2.3. Wi-Fi TCP communication card".
3. If you wish to use Ethernet communication with the router, insert the communication cabling through the
dedicated PG20 cable gland (see "2.7. Description of cable inlets").
4. In the case of using the Wi-Fi connection, connect the Reset button together with the extension cable
provided (A) and the antenna (B) to the EMS Board. To use the Ethernet connection, connect the cabling
to the EMS Board (C).
5. Connect the RS-485 cabling (D) for communication with the external wattmeter.
50
A
B
INGECON SUN EMS Board
Pin
1
J11
J12
C
D
Signal
RS-485 B(+)
ABH2015IQE01_ - Installation and Operation Manual
Connecting optional accessories