Chopper Reel Installation (Option) - Landoll Coulter Chisel 2112 Operator's Manual

ASSEMBLY INSTRUCTIONS
Chopper Reel Installation
(Option)
NOTE
Refer to See Figures 2-34
for Standard Chopper Reel Placement.
Refer to See Figures 2-46
for Hydraulic Chopper Reel Placement.
1. Models 2112-11, attach the harrow extension LT and
RT to plates on end of frame with 3/4 x 7 bolts, 3/4 x
2-1/2 bolts and 3/4 lock nuts
2. Attach the chopper arm long assemblies on rear of
center frame, RT side, and short arm assemblies, LT
side, to plates on rear of center frame with 3/4 x 2-1/2
bolts, 3/4 lock nuts See Figures
3. Remove the 3/4 x 5-1/2bolts, 3/4 lock nuts, gangbar
mount plates from harrow mount arms.
4. Attach the reel assemblies, secure with the u-bolts,
gangbar mount plates, nuts that were just removed
as shown See Figures
5. On hydraulic Chopper Reel option, install the hose
mount plate with the 1/2 x 8-1/2 bolt, 1/2 flat washer,
1/2 lock nut, the hose clamp attaches with 3/8 x 1-1/2
bolt, 3/8 flat washer, 3/8 lock nut.
3-38
through See Figures 2-43
through See Figures 2-53
See Figures 3-23.
3-29.
3-23.
6. On hydraulic Chopper Reel option, install the 8 port
manifold to manifold mount with 1/2 x 3-1/2 bolts, 1/2
lock nuts as shown See Figures
8 PORT MANIFOLD,
1/2 X 3-1/2 BOLT,
1/2 LOCK NUT
Figure 3-28: 8 Port Manifole Installation
7. On hydraulic Chopper Reel option,
through See Figures 3-33
installation.
3-28.
MANIFOLD MOUNT
BRACKET
See Figures 3-30
for proper hydraulic
F-1102-0721