Table of Contents
Advertisement
ASSEMBLY INSTRUCTIONS
Auto Reset Shank Installation
1. Attach each shank to each auto reset clamp
assembly using 3/4 x 4 bolt, lock nut in bottom hole
and 3/4 x 5 bolt, lock nut in top hole
Figures
3-11.
NOTE
For shallower depths, it may be necessary to move
shank into upper mounting holes. For certain
conditions shank may also be rotated forward when
using twisted shovels.
3-16
2. Install the 2" cast flat point onto shanks with 1/2 x
3. Install the 2" cast point onto shanks with 1/2 x 3-1/4
See
4. Connect TW RH & LH shovels to each shank using
IMPORTANT
Right and left twisted shovels are determined by
direction of dirt flow when facing the direction of
travel.
NOTE
The center twisted shovel may be replaced with a
straight point.
T
3-3/4 bolts, 1/2 hd flat washers and 1/2 heavy nuts.
bolts, 1/2 hd flat washers and 1/2 heavy nuts.
1/2 x 3 plow bolts, 1/2 hd flat washers and 1/2 heavy
nuts,
See Figures 2-4
through
locations of right hand and left hand shovels.
2-9
for proper
F-1102-0721
Advertisement
Table of Contents
