Table of Contents
Advertisement
Setting the feed-dog
Moving the stitch regulator gear sideways
Figure 25: Moving the stitch regulator gear sideways - Part 1
(10) - Assembly frame setscrew
8. Loosen the assembly frame setscrew (10) through the screw
9. Loosen the pusher eccentric setscrews (11).
Figure 26: Moving the stitch regulator gear sideways - Part 2
(4) - Assembly frame
(5) - Plates
(6) - Assembly frame screw
10.Loosen the screw (7).
11.Move the assembly frames (4) sideways such that they are exactly in
12.Tighten the adjusting ring and fasten the screw (7).
13.Tighten the pin and fasten the assembly frame setscrew (10) through
14.Fasten the pusher eccentric setscrews (11).
Service manual H867 Version 00.0 - 08/2013
(8) - Tension spring
(9) - Screw opening
opening (9) using a 3 mm hex key.
the center of the cut-outs for the sliding shafts (13).
Important: When doing so, make sure that the gear shaft is not moved
so far that the plates hit against the sliding shaft.
the screw opening (9).
Important: When fastening the pusher eccentric setscrews (11), make
sure that the feed movement of the feed-dog is correctly
set (
Section 9.2.1 Setting the feed movement, page 37).
(11) - Pusher eccentric setscrews
(12) - Pusher eccentric
(7) - Screw
(13) - Cut-outs for sliding shafts
(14) - Clamping screw
35
Advertisement
Table of Contents
