Setting The Stroke Movement - Dürkopp Adler M-TYPE H867 Service Manual

Setting the feed-dog

9.2.3 Setting the stroke movement

Sequence
First check the following settings:
• Feed-dog height (
Correct setting
At the front dead center (handwheel position 90°) and at the rear dead
center (handwheel position 270°) for the feed-dog, the upper edge of the
feed-dog is at the same height as the upper edge of the throat plates. At
90°, the feed-dog is in the upward movement; at 270°, in the downward
movement.
Cover
• Tilt the upper section backwards
Figure 30: Setting the feed-dog stroke
Setting steps
1. Loosen the stroke eccentric setscrews (1).
2. Put the handwheel into the 90° position.
3. Turn the stroke eccentric (2) such that the upper edge of the feed-dog
4. Tighten the stroke eccentric setscrews (1).
Service manual H867 Version 00.0 - 08/2013
WARNING
Risk of crushing
Switch the sewing machine off before you check and set the
stroke movement of the feed-dog.

top dead center, page 38)
(  Section 4.4.1 Access to the machine bottom section, page 10)
(1) - Stroke eccentric setscrews
is in the upward movement and at the same height as the upper edge
of the throat plates.
Section 9.2.2 Setting the feed-dog height in the
(2) - Stroke eccentric
39