Table of Contents
Advertisement
Figure 54: Setting the winder spacing
(3) - Winder flap
(5) - Engaging clamp
(6) - Winder wheel
Setting the winder spacing
10.Turn the winder spindle (12) such that the tear-off knife (11) is at the top
11.Loosen the setscrew in the engaging clamp (5).
12.Set the winder flap (3) such that the upper arm is above the marking for
13.Set the engaging clamp (5) such that it is resting against the locking
14.Set the engaging clamp (5) such that its distance to the winder wheel (6)
15.Tighten the setscrew in the engaging clamp (5).
Figure 55: Installing the winder
(1) - Winder screws
68
right and is facing the right-hand screw hole (13).
the XXXL hook (15).
The distance between the winder flap and the outer thread on the
bobbin is then 2 – 3 mm.
disc (14).
is 0.5 mm.
(11) - Tear-off knife
(12) - Winder spindle
(13) - Right-hand screw hole
(14) - Locking disc
(15) - Marking for XXXL hook
Service manual H867 Version 00.0 - 08/2013
Winder
Advertisement
Table of Contents
