Table of Contents
Advertisement
20.1.2 Draining the water condensation
Water condensation may accumulate in the water separator of the pres-
sure controller.
Correct setting
The water condensation must not rise up to the level of the filter
element (1).
Check the water level in the water separator on a daily basis.
Figure 69: Draining the water condensation
(1) - Filter element
(2) - Water separator
Maintenance steps
1. Place the collection tray under the drain screw (3).
2. Unscrew the drain screw (3) completely.
3. Allow water to drain into the collection tray.
4. Tighten the drain screw (3).
84
ATTENTION
Machine damage due to too much water
Too much water can cause damage to the machine. Check the water
level every day and drain water, if necessary.
WARNING
Risk of injury
Switch off the machine at the main power switch and discon-
nect it from the pneumatic network before you drain the water
from the water separator.
6
4
8
2
10
0
1
2
3
(3) - Drain screw
Service manual H867 Version 00.0 - 08/2013
Maintenance work
Advertisement
Table of Contents
