Dürkopp Adler M-TYPE H867 Service Manual page 77

Thread cutter
6. Turn the control cam (3) such that the roller (1) runs up at the contour
7. Tighten the control cam setscrews (4).
8. Check: Insert the thread into thread-pulling knife (6) and slowly turn the
Service manual H867 Version 00.0 - 08/2013
of control cam (3) and the widest extent of the control cam is at hand-
wheel position 60° at the highest point.
handwheel. Check in which handwheel position the thread is cut. If nec-
essary, repeat setting steps 1 – 7 until the cut takes place at 60°.
75