Table of Contents
Advertisement
Setting the potentiometer
Figure 63: Setting the potentiometer
6. Check whether the lifting gear plates are flush.
10.Loosen the setscrew (3) for the shaft.
11.Turn the potentiometer axle such that the left display shows 1 in the first
12.Tighten the setscrew (3) without changing the value shown in the dis-
13.Press the ESC key two times.
Important:
14.Switch off the machine at the main power switch.
15.Switch on the machine at the main power switch.
Service manual H867 Version 00.0 - 08/2013
(1) - Connecting clamp setscrews
(2) - Connecting clamp for lifting cylinder
If the plates are not flush:
7.Loosen the connecting clamp setscrews (1).
8.Set the connecting clamp (2) for the lifting cylinder such that the plates
are flush.
9.Tighten the connecting clamp setscrews (1).
instance and the relevant maximum speed next to it.
play.
Switching off and on will save the setting.
(3) - Setscrew for the setting shaft
(4) - Potentiometer
77
Advertisement
Table of Contents
