Setting The Lower Stitch Length Adjusting Wheel - Dürkopp Adler M-TYPE H867 Service Manual

Setting the stitch length adjusting wheels

8.2 Setting the lower stitch length adjusting wheel

Checking the correct setting
Sewing with two different stitch lengths:


Cover
• Tilt the upper section backwards
Figure 19: Setting the lower stitch length adjusting wheel
(1) - Key for the stitch length on the
Setting steps
1. Switching over to the smaller stitch lengths:
2. Repeat steps 2 to 11 from the previous section (
Service manual H867 Version 00.0 - 08/2013
WARNING
Increased risk of injury!
The lower stitch length adjusting wheel has to be set when the
machine is switched on, because a switchover is automatically
made to the upper adjusting wheel when the machine is
switched off.
The stitch lengths on the seam correspond with the set stitch lengths.
The lower stitch length adjusting wheel can only be turned up to the
stitch length set on the upper stitch length adjusting wheel.

( Section 4.4.1 Access to the machine bottom section, page 10)
machine arm
The key for the stitch length on the machine arm (1) must be off. If it is
lit up:
Press the key (1).
the upper stitch length adjusting wheel, page 25) for the lower stitch
length adjusting wheel (3).
+/– +/–
(2) - Upper stitch length adjusting wheel
(3) - Lower stitch length adjusting wheel

12
Section 8.1 Setting
27