Table of Contents
Advertisement
Sewing feet
Figure 46: Setting the point in time for when the feeding foot touches down
Setting steps
1. Screw in the setscrew (3) so that a stroke is available.
2. Position the upper stitch length adjusting wheel to 0.
3. Loosen the stroke eccentric setscrews (2).
4. Turn the stroke eccentric (1) such that the feeding foot touches down
5. Tighten the stroke eccentric setscrews (2).
6. Unscrew the setscrew (3) far enough so that there is no longer any
Service manual H867 Version 00.0 - 08/2013
(1) - Stroke eccentric
(2) - Stroke eccentric setscrews
on the feed-dog when the handwheel is in the 95° position.
Important: Do not move the stroke eccentric (1) laterally on the axle in
doing so.
contact with the clamp.
(3) - Setscrew
59
Advertisement
Table of Contents
