Programming A Working Day; Programming The Heating Unit Pressure; Programming The Cup Warmer; Programming The Automatic Steam Wand Temperature - Astoria 1GR Use And Maintenance Manual, Instructions For The User

6.11.4 Programming a Working Day

This menu is used to programme the machine's switch-off
function for non-operating days.
To set the machine's shutdown days, follow the instructions
below.
• Enter the programming mode and scroll through the menu
until the following is shown on the display:
WORKING DAYS
1234567
• At this moment, the machine is active seven days a week
because all the numbers (which define the relative days)
are visible.
Days of the week table
1 Monday
2 Tuesday
3 Wednesday
4 Thursday
• To switch off the machine on a specific day, select the de-
sired day via the (+) and (-) buttons.
• Press the (ENTER) button to deactivate the desired work-
ing day.
• Then, and only is desired, select another working day and
press the (ENTER) button to deactivate it.
WORKING DAYS
1-3-567
An example of when the machine has been programmed to
be switched off on Tuesdays and Thursdays.
On the days of the week in which the machine will
be switched off, the "-" symbol appears instead of
the relative number.
If you want to reactivate the machine on the previously-deac-
tivated days, proceed as follows:
• Select the deactivated day via the (+) and (-) buttons
(where the "-" symbol appears).
• Press the (ENTER) button to activate the desired day (the
day number will now appear).
WORKING DAYS
1234567
Example of the machine with no programmed shutdown
days.
Once the programming is complete, press the (MODE) button
to confirm the entered parameters and move on to the next
programming function.
54 216
of
5 Friday
6 Saturday
7 Sunday
6.11.5 Programming the Heating Unit
Pressure
This menu is used to program the heating unit pressure for
dispensing steam.
• Enter the programming mode and scroll through the menu
until the following is shown on the display:
PRESS. HEATING UNIT
1.0 BAR
• Set the heating unit pressure (values from 0.9 to 1.2 bar)
via the (+) and (-) buttons.
• To confirm the entered parameters and move on to the
next programming function, press the (MODE) button.

6.11.6 Programming the Cup Warmer

This menu is used to program the cup warmer temperature
and activation.
• Enter the programming mode and scroll through the menu
until the following is shown on the display:
CUP WARMER
• Set the temperature (70-100°C) via the (+) and (-) buttons.
• To confirm the entered parameters and move on to the
next programming function, press the (MODE) button.
To disable the cup warmer, set a temperature lower
than 70°C (---- will appear on the display) or turn
the cup heater switch to OFF.
HIGH TEMPERATURE HAZARD: Please remember
that a very high temperature can cause very seri-
ous burns.
6.11.7 Programming the Automatic
Steam Wand Temperature
This menu is used to programme the automatic steam wand
activation temperature:
• Enter the programming mode and scroll through the menu
until the following is shown on the display:
AUTOMATIC STEAM WAND
• Set the temperature via the (+) and (-) buttons.
• To confirm the entered parameters and move on to the
next programming function, press the (MODE) button.
The actual temperature of the beverage may differ
by a few degrees from the set temperature de-
pending on the amount of the beverage heated.
CURR = 7
80 °C
65 °C
USER manual