Aep" Version; Sae - Display" Version; Dispensing Steam - Astoria 1GR Use And Maintenance Manual, Instructions For The User

6.5.3

"AEP" version

• Place a cup/demitasse under the group's dispensing spout.
• Press the desired dispensing button
will start dispensing coffee; when the desired amount of
coffee has been dispensed into the cup, press the switch
again to stop dispensing.

"SAE - DISPLAY" version

6.5.4
DISPENSING COFFEE
• Place a cup/demitasse under the group's dispensing spout.
• Press the desired dose button, e.g.
coffee to be dispensed (LED will switch on).
• To stop the coffee dispensing ahead of time, press the
or button.
Should an anomaly occur or the push button panel
freeze, use the manual switch (see the "AEP" ver-
sion).
PROGRAMMING THE COFFEE
Each dose must be programmed with freshly
ground coffee and not with previously-used coffee
grounds.
The machine is programmed by default. Should the coffee
doses need to be modified, proceed as follows:
• Always programme the pushbutton panel of the right-
most group first. This way, all the pushbutton panels will
be automatically programmed. If necessary, subsequently
programme the others.
48 216
of
• Place a cup/demitasse under the group's dispensing spout.
• Press the
dose button LEDs are lit.
: the machine
• Press the dose button that you would like to programme,
e.g.
grammed).
• To confirm the dose, press the
• If desired, repeat this operation for the other dose but-
tons.
and wait for the
• When the programming is complete, press the
ton until all of the LEDs on the push-button panel go off.
groups one by one as illustrated above.

6.6 Dispensing steam

The steam dispensing method is different for each machine
type; therefore, the instructions specific to the model being
used must be followed.
To optimally froth the milk, follow these simple rules:
• Only heat the amount of milk that you intend to use; once
heated, it will have to be completely poured out of the jug
and cannot be reheated.
• Froth the milk which should be at a temperature of around
4°C.
In any case, before proceeding to dispense steam, the follow-
ing precautions must always be followed.
button for at least 5 seconds, until all the
(the button will flash whilst it is being pro-
button.
All the groups will now be programmed this way.
Should you wish to programme them differently,
proceed to singularly programme the left-hand
button again or the
but-
USER manual