Programming Doses; Programming Coffee Doses; Programming Hot Water Doses - Astoria futura +4U User Manual

9

Programming doses

9.1 Programming coffee doses

To program the dose keys, proceed as follows:
insert the prog. smart card into the programming
reader (7) as indicated in the drawing;
press and hold the "PROG/STOP" key down for
5 seconds: the LED of the "PROG/STOP" key will
flash and all keys on the push-button panel being
programmed will turn on;
fill the filter with a dose of ground coffee and
press it with the coffee press;
attach the portafilter to the delivery group;
put the coffee cup under the dispensing spout;
press the desired dose key (e.g.: "1 Espresso"
wait for delivery;
to confirm the desired dose press again the dose
key or the "PROG/STOP" key;
once the dose is confirmed, the LED of the pro-
grammed key switches off and only the keys yet
to be set remain on;
repeat this operation for the other dose but-
tons;
when finished programming, press the key
"PROG/STOP" until all LEDs go off on the push
button panel and remove the smart card from
the reader (7).
40
);
7
After 30 seconds of idle time, the machine
i
will automatically exit the dose programming
mode, confirming the already programmed
ones.
i
The programming of each dose must be carried
out with ground coffee and not with previously
used coffee grounds.
It is possible to program all the push-button
panels of the machine simultaneously using
i
only the left push-button panel. To obtain dif-
ferent doses for the various groups, perform the
programming by starting with the left push-
button panel and then all the others.

9.2 Programming hot water doses

To program the hot water doses, proceed as fol-
lows:
insert the prog. smart card into the programming
reader (7) as indicated in the drawing ;
place the cup under the hot water nozzle;
press and hold down the "PROG/STOP" key on
the left push-button panel until all dose key LEDs
switch on;
press the hot water delivery key
when the desired dose has been reached, confirm
by pressing the hot water key
repeat the operation for the other dose button;
when finished programming, press the key
"PROG/STOP" and remove the smart card from
the reader (7).
All models are provided with 2 keys for the
i
dispensing of hot water. These can be pro-
grammed individually and supply doses which
are independent from one another.
The 4GR version has 2 hot water nozzles. The
i
left key controls the left hot water nozzle,
while the right key controls the right hot water
nozzle.
;
again;
User manual