Connections; Transmitter Rear Panel Connections - Extron electronics DTP2 T/R 211 User Manual

Hdmi twisted pair transmitters and receivers
Table of Contents

Advertisement

12.
13.
14.
After the transmitter, the receiver, and their connected devices are powered up, the system
is fully operational. If any problems are encountered, ensure all cables are routed and
connected properly.
NOTE: Ensure the video source and display selected for the DDC are properly

Connections

Transmitter Rear Panel Connections

Figure 2.
A
In a DTP2 transmitter to DTP2 receiver configuration, set the SEND POWER
toggle switch to the UP position on the powered DTP2 device to enable sending
remote power to the far end DTP2 device. Set the toggle switch to the DOWN position on
the DTP2 device receiving power (see figure 9,
ATTENTION:
The DTP2 211 device is configured to output power to DTP2 models only. If
connected to a Legacy DTP device, set the toggle switch to the DOWN (OFF)
position. Failure to turn the power OFF will damage the connected Legacy
DTP device.
Le DTP2 211 est configuré pour fournir une alimentation aux modèles
DTP2 uniquement. S'il est connecté à un autre appareil, veuillez positionner
l'interrupteur à bascule sur « DOWN » (OFF). Si l'interrupteur n'est pas
positionné sur OFF, vous risquez d'entraîner la défaillance de l'appareil
Legacy DTP connecté.
Connect power to the transmitter or receiver.
Power on the source devices.
connected to the transmitter and receiver pair, and the transmitter, receiver, and
display have power applied before power is applied to the video source. If the other
devices are not turned on before the video source, the image may not appear.
INPUTS
POWER
12V
AUDIO
0.8A MAX
A A
A
B
B B
C
C C
DTP2 T 211 Transmitter Connectors
Power inlet — Plug the included external 12 VDC power supply into either this 2‑pole
inlet or the power inlet on the receiver (see figure 3,
Supply Wiring
on page 12 to wire the connector).
on page 15).
D
Power inlet
A
OVER DTP2
SIG
LINK
Audio input
B
RS-232
IR
HDMI input
C
Tx Rx
G
Tx Rx
DTP2 OUT
DTP2 Output RJ-45 port
D
D D
D
E E
E
Over DTP2 RS-232 and IR port
E
A
DTP2 T/R 211 • Installation and Operation
on page 8, and
Power
6

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dtp2 t 211Dtp2 r 211

Table of Contents