Table of Contents
Advertisement
Operations
Front Panel Features
Panel
STATUS
SEND
INPUT
POWER
LINK
G
OUTPUT
OFF
DTP2 T 211
C
C
C
D
D
D
DTP2 T 211 Front Panel
STATUS
INPUT
LINK
CONFIG
OUTPUT
A
A A
B
B B
C
C C
DTP2 R 211 Front Panel
STATUS
INPUT
LINK
CONFIG
OUTPUT
A
A
A
B
B
B
C
C
C
Figure 9.
Front Panels of the DTP2 211 Transmitter and Receiver
Power LED — Lights when the unit is receiving power, either locally or remotely (over
A
the DTP cable).
Configuration port — Using a USB cable, plug a PC into the transmitter or receiver
B
via this front panel mini‑USB connector for firmware updates (see
Front Panel USB Port
Status LEDs
C
Input Signal — Lights when the unit is receiving a TMDS clock signal on the HDMI
•
input (transmitter), or any valid signal on the DTP In connector (receiver).
DTP Link Status — Lights when a transmitter or receiver detect a sink signal from
•
a connected DTP device.
•
DTP Output Signal — Lights when the transmitter or receiver establish
communication with the connected DTP2 or Legacy DTP device.
NOTE: The front panel LEDs are tied to the rear panel LEDs on the DTP2 port.
Send Power toggle switch — In a DTP2 transmitter to DTP2 receiver configuration,
D
set the toggle switch to the UP (SEND POWER) position on the powered DTP2 unit to
enable sending remote power to the far end. Set the toggle switch to the DOWN (OFF)
position on the DTP2 unit receiving power (see
switch configuration).
ATTENTION:
•
The DTP2 211 device is configured to output power to DTP2 models only. If
connected to a Legacy DTP device, set the toggle switch to the DOWN (OFF)
position. Failure to turn the power OFF will damage the connected Legacy
DTP device.
•
Le DTP2 211 est configuré pour fournir une alimentation aux modèles
DTP2 uniquement. S'il est connecté à un autre appareil, veuillez positionner
l'interrupteur à bascule sur « DOWN » (OFF). Si l'interrupteur n'est pas
positionné sur OFF, vous risquez d'entraîner la défaillance de l'appareil
Legacy DTP connecté.
DTP2 R 211 Front Panel
SEND
POWER
DTP2 T 211
OFF
D
D D
SEND
POWER
OFF
DTP2 R 211
D
D
D
on page 17).
figure 10
DTP2 T/R 211 • Installation and Operation
STATUS
SEND
INPUT
POWER
LINK
CONFIG
OUTPUT
Power LED
OFF
A
Configuration port
B
A A
A
B B
B
C C
C
D D
D
Status LED
C
Send Power toggle switch
D
Connecting to the
on page 16 for toggle
DTP2 R 211
15
Advertisement
Table of Contents
