Table of Contents
Advertisement
Select Yes, now and every time I connect a device (see figure 12,
•
page 17) if you want the computer to automatically connect to Windows Update
to search the web every time the transmitter or receiver is connected to this USB
port.
•
Select No, not this time (
Windows Update to search the web at this time (for example, if the driver is already
on your computer).
3.
Click Next (
The next screen of the Wizard opens:
Figure 13.
4.
Select Install the software automatically (Recommended) radio button (see
figure 13,
5.
Click Next (
NOTE: You do not need to insert an installation disc.
The PC locates the driver needed and installs it in the correct location on the hard drive.
6.
When the Completed screen appears, click Finish to close the wizard.
NOTE: The wizard opens only on the first occasion you connect the transmitter
or receiver to that USB port. The wizard reappears if you connect the unit to a
different USB port or if you connect a different piece of equipment, requiring a
different driver, to the same USB port.
7.
Configure the transmitter or receiver as required using SIS Commands (see
Control
Resetting
Use the SIS command to reset the transmitter or receiver to its factory default settings (see
Reset
on page 23).
) if you do not want the computer to connect to
3
).
4
1
1
Installing the Software Automatically
).
1
).
2
starting on page 20).
2
2
DTP2 T/R 211 • Installation and Operation
on
2
Remote
18
Advertisement
Table of Contents
