Installation And Operation; Mounting The Units; Connections And Indications - Extron electronics PowerCage FOX 4G Tx DVI User Manual

Installation and
Operation
This section describes the installation and operation of the PowerCage FOX 4G VGA and
PowerCage FOX 4G DVI, including:
•
•
•
•

Mounting the Units

The PowerCage FOX 4G transmitter or receiver must be installed in an Extron PowerCage
enclosure. See

Connections and Indications

12
4
3
1
Figure 2.
a
b
Mounting the Units
Connections and Indications
PowerCage Front Panel Port, Control, and Indicators
Operation
Installing a Board in the
Transmitters
PowerCage PowerCage
FOX 4G Tx VGA FOX 4G Tx DVI
12
7
6
4
5
3
2
PowerCage
PowerCage
FOX 4G Tx DVI
FOX 4G Tx VGA
PowerCage FOX 4G Tx Transmitter Connectors
VGA Input connectors (PowerCage FOX 4G VGA only) — Connect an analog
VGA-UXGA RGB video source to this 15-pin HD female connector.
DVI-I Input connector (PowerCage FOX 4G DVI only) — Connect a single link
of DVI-D to this DVI-I connector. See
assignments.
NOTE:
The FOXBOX 4G DVI accepts only the digital signals on the DVI-I Input
connector. The analog pins on the port are not connected.
PowerCage FOX 4G DVI and PowerCage FOX 4G VGA • Installation and Operation
Enclosure.
Receivers
PowerCage
FOX 4G Rx VGA
12
7 8
6 6
4
5 5
11
9
PowerCage
FOX 4G Rx VGA
DVI connector (PowerCage FOX 4G DVI)
PowerCage
FOX 4G Rx DVI
12
8
6
4
5
11
10
PowerCage
FOX 4G Rx DVI
for pin
6