Table of Contents
Advertisement
Receiver Rear Panel Connections
POWER
OVER DTP2
12V
0.8A MAX
RS-232
Tx Rx
A
A A
Figure 3.
Power inlet — Plug the included external 12 VDC power supply into either this 2‑pole
A
inlet or the power inlet on the transmitter (see
Supply Wiring
NOTES:
•
•
•
Over DTP2 RS-232 and IR port — Connect a serial RS‑232 signal, a modulated IR
B
signal, or both to this 3.5 mm, 5‑pole captive screw port for bidirectional RS‑232 and
IR communication (see
connector).
DTP2 In RJ-45 port — Connect one end of the TP cable from the transmitter output
C
to this RJ‑45 port. Ensure the opposite end of this cable is connected to the transmitter
DTP2 Output RJ‑45 port (see figure 2,
•
Signal LED — This green LED indicates the unit is receiving a valid signal on the
DTP In port.
•
Link LED — This amber LED indicates a valid link is established between the units
on the DTP input and output cable.
NOTE: See
properly wire the RJ‑45 connectors and detailed
HDMI output — Connect a display with an HDMI input port (or DVI input port, with an
D
appropriate adapter) to display the transmitted digital image.
NOTE: See
HDMI connector to the transmitter and the receiver.
Audio configuration toggle switch —
E
Set the toggle switch to the DOWN position to de‑embed digital audio from the HDMI
•
signal and output it to the captive screw output for analog audio output.
•
Set the toggle switch to the UP position for the analog input from the TRS audio
port on the Tx unit to be transported simultaneously with the digital embedded
HDMI audio and output on the captive screw output (see figure 3,
Audio De-embedding (Receiver)
SIG
LINK
OUTPUTS
IR
G
Tx Rx
DTP2 IN
B
B B
C C
C
D D
D
E
E E
DTP2 211 Receiver Connectors
on page 12 to wire the connector).
One power supply is included with the transmitter and can normally power
both units. Remote power is only available if both the transmitter and the
receiver are from the Extron DTP2 series.
The power supply can be plugged into either the transmitter or the receiver to
power both units.
If the internal jumper setting for ground is removed, a DTP2 211 unit cannot
remotely power the other unit, because of ground potential differences. Each
unit requires a local power supply (see
RS-232 and IR Connector Wiring
TP Cable Termination and Recommendations
Securing the HDMI Connector
Power inlet
A
Over DTP2 RS‑232 and IR port
B
AUDIO
DTP2 IN RJ‑45 port
C
L
R
HDMI output
D
Audio configuration toggle switch
E
F
F F
Audio output
F
figure 2,
on page 6, and
A
Internal Settings
on page 14 to wire the
on page 6).
D
NOTES
on page 10 to securely fasten the
on page 19).
DTP2 T/R 211 • Installation and Operation
Power
on page 32)
on page 11 to
on page 11.
and
HDMI
E
8
Advertisement
Table of Contents
