Extron electronics DTP2 T 202 FB Setup Manual

DTP2 T 202 FB • Setup Guide
This guide provides instructions for an experienced installer to install
the Extron DTP2 T 202 FB switching transmitter into an Ackermann
GB3 (OBO Betterman), MK Electric CableLink Plus Modular, MK Electric
CableLink Plus Single Pan,
ElectraPlan, or PUK floor box
and to make all connections.
The transmitter switches
between two digital video
inputs (HDMI and DisplayPort)
and, paired with a compatible
receiver, can extend the
selected signal up to 330 feet
(100 m).
Installation
Planning
CAUTION:
Failure to check these items may result in personal injury or property damage.
ATTENTION :
La non-vérification des éléments listés ci-dessous peut provoquer des blessures ou dommages matériels.
Check that the installation meets the building, electrical, and safety codes.
Mounting and Cabling
Step 1 — Preparing the floor box
Install the floor box as directed by the manufacturer.
a.
NOTE: Run all required cables and secure them with cable clamps.
Turn off or disconnect all equipment power sources.
b.
Step 2 — Installing adapters
Determine a position in the floor box to mount the switching transmitter (see the image
a.
at right).
Identify the applicable adapter plates for the floor box (see the table below).
b.
Install adapter plates to the same pair of mounting slots (see the table below for slot
c.
recommendations) for the same position in the floor box. Slide the top flange into the
mounting slot and rotate the adapter plate down so the bottom flange rests against the
wall of the floor box.
Floor Box
Ackermann GB3
(OBO Betterman)
MK Electric CableLink Plus
Single Pan
MK Electric CableLink Plus Modular
ElectraPlan
PUK
G
E
SEND POWER OFF HDBT DTP
OVER TP
POWER
REMOTE
12V
IR RS-232 OUT
RS-232
1.4A MAX
A
B
G Rx Tx Rx Tx G Rx Tx
LINK SIG
C
Side Panel
Figure 1.
Side (under adapter plate)
(Before installation in floor box)
A DC power input
B Remote RS-232
C RS-232/IR Over TP output
D DTP output
E Send power switch
F TP function switch
Adapter Plates
995241 (2)
995241 (2) and 995242 (1)
995243 (2)
995244 (2)
995300 (2)
995300 (2)
J
H
K
I
F
D
Top Panel
DTP2 T 202 FB Unit features
Side (above adapter plate)
(After installation in floor box)
G HDMI input
H Audio input
I DisplayPort Input
Positions Highest Additional Notes
Mounting Slot
1 and 3 3rd from top For position 2, use the provided screws to attach
2 the 995242 adapter plate to either 995241
adapter plate.
1 and 3 / Do not use position 2. Use mounting screws to
N A
secure the adapter plates to the floor box (see
figure 3
1, 2, and 3 3rd from top
1, 2, and 3 3rd from top
1, 2, and 3 3rd from top
L
Top
J Configuration (USB)
K Reset button
L LED indicators
1
2
3
Typical Floorbox
on page 3).
1