Table of Contents
Advertisement
Status Preset
:STATus:PRESet
This command is used to set certain status values to defined values.
a) The OPERation and QUEstionable enable registers are cleared.
b) The Positive transition filters are set to 32767.
c) The Negative transition filters are set to 0.
d) Only errors in the range (-440:-100) are enabled to be reported in the event queue.
Command Type:
Setting
Syntax:
Error Queue Read
:STATus:QUEue?
This query returns the first entry in the error queue, and removes that entry from the queue. Its
function is identical to that of the :SYSTem:ERRor? query.
Command Type:
Query
Syntax:
Response:
Error Queue Enable
:STATus:QUEue:ENABle
This command is used to enable individual errors to be placed in the queue when they occur. Those
errors not specified in the :ENABle command are disabled from being reported in the error queue.
Errors and events enabled to be reported at power on depends on the Power on Status Clear status (set
with the *PSC common command). If PSC is set, the status is cleared on power on, and the range of
errors enabled is as set by the STATus:PRESet command, ie -440 to -100. If PSC is cleared, the status is
not cleared on power on, and the errors and events enabled are those that were enabled before the
last power down.
1.800.544.2843
:QUEStionable
:CONDition?
:PTRansition <NRf>
:NTRansition <NRf>
:EVENt?
:ENABle <NRf>
Setting only
:STATus:PRESet
Query only
:STATus:QUEue[:NEXT]?
<Error number>, "<error description>"
www.calcert.com
15
10
20
5
25
0
30
81
sales@calcert.com
Advertisement
Table of Contents
