Table of Contents
Advertisement
1.800.544.2843
Figure 3.4 - Arbitrary Menu
F1: Start
- Selects the starting address of the arbitrary waveform.
F2: Length - Selects the length of the arbitrary waveform. Use the START and LENGTH
menu selection to mark a selection of the waveform memory that will be
executed.
Note: The maximum Length allowed depends on model.
F3: Mark
- (Marker Output) Selects the marker output address of the signal to be
available at the Marker Out connector. The F2: ADDR, F3: LENGTH or F4:
ON/OFF can be selected and the Marker output signal can be available at
th
every 4
location address between the start and stop addresses of the
executed waveform, starting from address 1 (i.e. 1, 5, 9, 13, etc.). This
marker output feature will allow you to generate a positive TTL level
output signal at the points specified by address and length.
Note: The maximum Length allowed to be set for marker is 4000. Marker
Length can be set at every 4
12, etc.)
Figure 3.5 - Marker Menu
Below is an illustration of how the marker function works:
www.calcert.com
15
10
20
5
25
0
30
th
location address starting from 4 (i.e. 4, 8,
13
sales@calcert.com
Advertisement
Table of Contents
