Table of Contents
Advertisement
F1: Recall
F3: Store
F2: Load ARB - Selecting this will load the selected Arbitrary waveform data points.
F4: Save ARB - Selecting this will save the current Arbitrary waveform data points so that it can be
1.800.544.2843
- Recalls a previously stored front-panel setup from the selected storage location.
Change the storage location number by using the rotary input knob. Valid storage
location numbers are from 0 to 49. Location 0 is a read-only buffer that contains the
power-on settings listed in Table 3.3.
- Stores the current front-panel setup to the specified storage location. Change the
storage location number by using the numeric keypad or the rotary input knob. Valid
storage location numbers range from 1 to 49. Below is a list of parameters that can be
stored in each storage location.
Table 3.3 - List of Stored Parameters
When the ARB waveform is selected, the setup menu is as shown:
Figure 3.21 - Setups Menu (with Arbitrary waveform selected)
recalled when revisiting the ARB menu later on or when power cycling the instrument.
www.calcert.com
15
10
20
5
25
0
30
Stored
Parameters
FREQUENCY
RATE(ARB)
AMPLITUDE
FUNCTION
OFFSET
REPETITION
MODE
N-BURST
START ADRS
WAVELENGTH
TRIG SOURCE
OUTPUT
SWEEP
MODULATION
24
sales@calcert.com
Advertisement
Table of Contents
