Table of Contents
Advertisement
F2: Start
F3: Stop
F4: Rate
F5: Lin/Log
How to Set up Sweep in Different Modes
By default, turning ON the sweep function will automatically set to a continuous (Cont) sweep. In order
to change to other modes of sweep, do the following:
1. Set sweep to On by pressing F1.
2. Press the MODE button on the front panel.
3. Select between triggered (Trig), burst (Burst) or gated (Gate) mode.
Note: If this is done before turning on sweep, sweep On selection will automatically reset to
default (continuous mode).
MODULATION Key
Selects the modulation mode AM, FM, or FSK.
To select the modulation mode, press MODUL key and then press the function key that corresponds to
the desired menu option.
F1: AM
1.800.544.2843
- Defines the Sweep Start frequency.
- Defines the Sweep Stop frequency.
- Defines the Sweep Rate.
- Selects Linear or Logarithmic Sweep.
Figure 3.16 - Modulation Menu
- If AM is selected, the following menu is available:
www.calcert.com
15
10
20
5
25
0
30
21
sales@calcert.com
Advertisement
Table of Contents
