Table of Contents
Advertisement
F1: Cont
F2: Trig
F3: Gate
F4: Burst
F5: Phase
After selecting the TRIG, GATE or BURST menu, the trigger source menu is available:
1.800.544.2843
Figure 3.12 - Mode Menu
- (Continuous) - Selects continuous output.
- (Triggered) - Triggers one output cycle of the selected waveform for each trigger
event.
- (Gate) - Triggers output cycles as long as the trigger source asserts the gate signal.
- (Burst) - Triggers output N output cycles for each trigger event, where N ranges from
2 to 999999.
- Selects the start phase of the signal in non-continuous modes. The range is from -
180˚ to +180˚, with a 0.1˚ resolution.
When Phase Menu is selected the following screen is displayed:
Figure 3.13 - Phase Menu
F1: Phase
- Sets the phase.
F2: SET-Zero
- Sets the phase reference to zero.
F3: SYNC Both Ch. - For Dual Channel models, pushing this key synchronizes both
channels in between with a phase shift as in the Phase parameter
entered (or 0 after pushing SET-Zero).
www.calcert.com
15
10
20
5
25
0
30
19
sales@calcert.com
Advertisement
Table of Contents
