Table of Contents
Advertisement
-170
-171
-178
Execution Errors
An execution error indicates that the device could not execute a syntactically correct command, either
since the data were out of the instrument's range, or due to a device condition. The EXE bit (bit 4) of
the Standard Event Status Register is set on occurrence of an execution error.
-200
-201
-211
-220
-221
-222
-223
-224
-241
-258
Device-Specific Errors
An error specific to the device occurred. The DDE bit (bit 3) of the Standard Event Status Register is set.
-315
-330
-350
Query Errors
1.800.544.2843
Expression error
Only 6 error ranges may be specified.
Invalid expression
An error was found in the expression.
Expression data not allowed
Execution error
An attempt was made to RECALL the contents of an uninitialized stored
setting buffer.
Invalid while in local.
Trigger ignored.
The GET or *TRG common command was ignored due to the device not
being in the correct state to execute the trigger.
Parameter error.
A parameter is in the correct range, but conflicts with other parameters.
Settings conflict.
The parameter is out of range due to the current instrument state.
Data out of range.
Too much data.
The arbitrary waveform memory limit has been exceeded.
Illegal parameter value.
The parameter value must be selected from a finite list of possibilities.
Hardware missing; A command was sent to operate a non-existent
channel.
Media protected.
An attempt was made to write to protected arbitrary waveform memory.
Configuration memory lost.
Device memory has been lost.
Self-test failed.
Queue overflow.
Error codes have been lost due to more than 10 errors being reported
without being read.
46
www.calcert.com
15
10
20
5
25
0
30
sales@calcert.com
Advertisement
Table of Contents
