Part 2.5: Emmc Flash - Alinx ZYNQ7000 FPGA User Manual

Pin Assignment of QSPI Flash
Signal Name
QSPI_SCK
QSPI_CS
QSPI_D0
QSPI_D1
QSPI_D2
QSPI_D3

Part 2.5: eMMC Flash

The core board is equipped with a large capacity 8GB eMMC FLASH chip,
model THGBMFG6C1LBAIL, which supports the JEDEC e-MMC V5.0 standard
HS-MMC interface with level support of 1.8V or 3.3V. The data width of the eMMC
FLASH and ZYNQ connections is 4 bits. Due to the large capacity and non-volatile
nature of eMMC FLASH, it can be used as a large-capacity storage device for the
ZYNQ system, such as ARM-based applications, system files, and other user data
files. The specific models and related parameters of eMMC FLASH are shown in
Table 2-5-1：
Position
U33
eMMC FLASH is connected to the GPIO port of the BANK501 in the PS
section of the ZYNQ chip. In the system design, the GPIO port functions of these
18 / 60
ZYNQ FPGA Development Platform AX7015 User Manual
Figure 2-4-2: QSPI Flash on the Core Board
Table 2-4-2: Pin Assignment of QSPI FLASH
Model
THGBMFG6C1LBAIL
Table 2-5-1: eMMC FLASH Specification
Amazon Store: https://www.amazon.com/alinx
ZYNQ Pin Name
PS_MIO6_500
PS_MIO1_500
PS_MIO2_500
PS_MIO3_500
PS_MIO4_500
PS_MIO5_500
Capacity
8G Byte
Pin Number
A19
A22
A21
F17
E19
A20
Factory
TOSHIBA