Cage Clamp; Figure 4: Cage Clamp ® Connectors; Table 5: Legend For Figure "Cage Clamp ® Connectors - WAGO 750-563/040-000 Manual

20 Device Description
3.2.3

CAGE CLAMP

Figure 4: CAGE CLAMP
Table 5: Legend for Figure "CAGE CLAMP
Channel
1
2
Use shielded signal lines!
Only use shielded signal lines for analog signals and I/O modules which are
equipped with shield clamps. Only then can you ensure that the accuracy and
interference immunity specified for the respective I/O module can be achieved
even in the presence of interference acting on the signal cable.
For further information about shielding, see system manual WAGO-I/O-SYSTEM
750 XTR, section "Connect Devices" > ... > "Shielding."
Manual
Version 1.3.0
750-563/040-000 2AO 0/4-20mA/ 6-18V DC/ 16Bit /XTR
®
Connectors
®
Connectors
Designation Connector Function
+AO 1
+Sense AO 1
−Sense AO 1
Common
(ground)
+AO 2
+Sense AO 2
−Sense AO 2
Common
(ground)
WAGO-I/O-SYSTEM 750 XTR
®
Connectors"
1 Analog output 1
2 Positive sense connection for analog
output 1
3 Negative sense connection for analog
output 1
4
Common (ground) for analog output
5 Analog output 2
6 Positive sense connection for analog
output 2
7 Negative sense connection for analog
output 2
8
Common (ground) for analog output