Clone And Recall A Waveform - Owon TAO3000 Series User Manual

Figure 4-17: Play back waveform by software

Clone and Recall a waveform

Click to call up the menu panel. Click the Save softkey on panel. Select
Type in the bottom menu, select Clone in the left menu.
You can clone one or two channel waveforms between two cursors, and save
it as a cloned waveform into a USB memory device. The cloned waveform files
saved to a USB memory device are saved with the extension "ota".
You can also use OWON AG1022F or AG2052F signal generator to read *.ota
files and recall the cloned waveforms.
Clone Wave menu shows as follows:
Menu Setting
Type Clone
Mode
Out1
Out2
Out1&Out2
Source AG Output
Out1
CH1 CH2
CH3 CH4
AG Output
Out2
CH1 CH2
CH3 CH4
4.Advanced User Guidebook
Select the clone function.
Select the source mode.
The cloned waveform includes one waveform,
which will be used for AG Out1
The cloned waveform includes one waveform,
which will be used for AG Out2
The cloned waveform includes two waveforms,
which will be used for AG Out1 and AG Out2
Select the source, which will be used for AG Out1
Select the source, which will be used for AG Out2
67
Instruction