How To Save And Recall A Waveform - Owon SDS1052 User Manual

Seconds, 5 Seconds and Infinity. When the "Infinity" option is set for Persist Time,
the measuring points will be stored till the controlling value is changed. Select OFF
to turn off persistence and clear the display.
XY Format
This format is only applicable to Channel 1 and Channel 2. After the XY display format is
selected, Channel 1 is displayed in the horizontal axis and Channel 2 in the vertical axis;
the oscilloscope is set in the un-triggered sample mode: the data are displayed as bright
spots.
The operations of all control knobs are as follows:
 The Vertical Scale and the Vertical Position knobs of Channel 1 are used to set the
horizontal scale and position.
 The Vertical Scale and the Vertical Position knobs of Channel 2 are used to set the
vertical scale and position continuously.
The following functions can not work in the XY Format:
 Reference or digital wave form
 Cursor
 Trigger control
 FFT
Operation steps:
1. Push the Acquire button to show the right menu.
2. Select XY Mode as ON or OFF in the right menu.
Counter
It is a 6-digit single-channel counter. The counter can only measure the frequency of the
triggering channel. The frequency range is from 2Hz to the full bandwidth. Only if the
measured channel is in Edge mode of Single trigger type, the counter can be enabled. The
counter is displayed at the bottom of the screen.
Operation steps:
1. Push Trigger Menu button, set the trigger type to Single, set the trigger mode to
Edge, select the signal source.
2. Push the Acquire button to show the right menu.
3. Select Counter as ON or OFF in the right menu.

How to Save and Recall a Waveform

Push the Utility button, select Function in the right menu, select Save in the left menu.
4.Advanced User Guidebook
28