Use Pass/Fail Function - Owon TAO3000 Series User Manual

The XY menu:
Function Setting
Menu
Full Screen
OFF
This format is only applicable to Channel 1 and Channel 2. After the XY display
format is selected, Channel 1 is displayed in the horizontal axis and Channel 2
in the vertical axis; the oscilloscope is set in the un-triggered sample mode: the
data are displayed as bright spots.
The operations of all control knobs are as follows:
 When the HOR button is lit, the upper and lower knobs are used to set the
horizontal scale and position.
 When one of the channel buttons is lit, the upper and lower knobs are used
to set the vertical scale and position.
The following functions cannot work in the XY Format:
 Reference or digital wave form
 Cursor
 Trigger control
 FFT
Operation steps:
1. Click to call up the menu panel. Click the XY softkey on panel to
switch to the ON state.
2. To make the XY view full screen, select Full Screen as ON in the bottom
menu.

Use Pass/Fail function

The Pass/Fail function monitors changes of signals and output pass or fail
signals by comparing the input signal that is within the pre-defined mask.
Click to call up the menu panel. Click the P/F softkey on panel to switch to
the ON state.
The Pass/Fail menu:
Function
Setting
Menu
Start
Operate
Stop
4.Advanced User Guidebook
Description
ON
Turn on/off the full screen view in XY mode
Description
Start operation
Stop operation
91