Logic Trigger - Owon TAO3000 Series User Manual

Single Nth Edge
CH1
CH2
Source
CH3
CH4
Edge
Edge
Idle Time
Configure
Edge Num
Auto
Normal
Single
Mode
Holdoff
Holdoff
Sensitivity

Logic Trigger

Trigger according to logic relation.
In Logic Trigger mode, the trigger setting information is displayed on bottom
right of the screen, for example,
indicates that trigger type is Logic, logic mode is AND, CH1 high level and
trigger level is 0.00mV.
Logic Trigger menu list:
Menu Setting
Mode Logic
AND
Logic
Mode XNOR
XOR
4.Advanced User Guidebook
Set vertical channel trigger type as Nth Edge
trigger.
Select CH1 as the trigger source
Select CH2 as the trigger source
Select CH3 as the trigger source
Select CH4 as the trigger source
Trigger on the rising edge of the input signal when
voltage level meets the specified trigger level.
Trigger on the falling edge of the input signal when
voltage level meets the specified trigger level.
Set idle time before the edge counting in Nth Edge
Trigger. Click
to move cursor to choose which digit to be
set. Available range is 30ns-10s, default 100ns.
Set the edge number value of "N" in Nth Edge
trigger.
Acquire waveform even no trigger occurred
Acquire waveform when trigger occurred
When trigger occurs, acquire one waveform then
stop
100 ns - 10 s, click
before another trigger occur, click
cursor to choose which digit to be set.
Set the trigger sensitivity.
Instruction
Set vertical channel trigger type as Logic trigger.
Set logic mode as AND.
OR Set logic mode as OR.
Set logic mode as XNOR.
Set logic mode as XOR.
or to set idle time, click
or
37
to set time interval
to move
,