Implement Sampling Setup - Owon TAO3000 Series User Manual

EventTable
Save
EventTable
ASCII Table

Implement Sampling Setup

Click to call up the menu panel. Click the Acquire softkey on panel, Acqu
Mode, Length, PERF Mode, and Intrpl is shown in the bottom menu.
The description of the Acqu Mode menu is shown as follows:
Function Menu
Sample
Peak
Detect
Acqu
Mode
Average
Refresh
Rate
The description of the Record Length menu is shown as follows:
Function Menu
Length
The description of PERF Mode menu is shown as follows:
Function Menu
PERF Mode
4.Advanced User Guidebook
ON
Select "ON" to display the event table.
OFF
If a USB storage device is currently connected to the
instrument, save the event table data in a .csv
(spreadsheet) formatted file on the external USB
storage device.
ON
Select "ON" to display the ASCII table.
OFF
Setting Description
Normal sampling mode.
Use to capture maximal and minimal
samples. Finding highest and lowest
points over adjacent intervals. It is used
for the detection of the jamming burr and
the possibility of reducing the confusion.
It is used to reduce the random and
4, 16, 64, 128 don't-care noises, with the optional
number of averages.
Set the waveform refresh rate, you can
 Low
turn on this mode when you need to
observe a single waveform
Setting
1000
10K
100K
1M
10M
20M
40M
Setting
8-bit
49
Description
Choose the record length
Note: When four channels are turned on,
the max record length is 10M; and max
20M for two channels; max 40M for one
channel.
Description
Set the vertical resolution (A/D)