Save And Recall A Waveform - Owon TAO3000 Series User Manual

Single, set the trigger mode to Edge, select the signal source.
2. Click , click the Display softkey on panel.
3. Select Counter as ON or OFF in the bottom menu.

Save and Recall a Waveform

Click to call up the menu panel. Click the Save softkey on panel, you can
save the waveforms, configures, screen images, record or clone the waveform.
The description of the Save Function Menu is shown as the following table:
Function Menu
Type
When the type is Wave, the menu shows as following:
Type
Wave
Source
Object
Object
Show
& Show
4.Advanced User Guidebook
Setting Description
Wave Choose the saving type.
Configure About the Record type, see
Image "Record/Playback Waveforms" on P63.
About the Clone type, see "Clone and
Record
Recall a waveform" on P67.
Clone
For internal storage, only BIN can be
Format
selected. For external storage, the
(Right menu)
format can be BIN, TXT or CSV.
CH1
CH2 Check the waveform to be saved. (If
CH3 certain
CH4 corresponding
Math disabled.)
(or MathFFT)
Wave0 to Choose
Wave99 waveform is saved to or recall from.
Recall or close the waveform stored in
the current object address. When the
show is ON, if the current object
address has been used, the stored
ON
waveform will be shown, the address
OFF
number and relevant information will be
displayed at the top left of the screen; if
the address is empty, it will prompt
"None is saved".
Close all the waveforms stored in the
Close All
object address.
56
channel is off,
menu item
the address which
the
will be
the