Print The Screen Image - Owon TAO3000 Series User Manual

Trigger Source
Trigger Coupling
Trigger Slope
Trigger Level
Trigger Mode
Display Format
Force
Help
Pass/Fail
Inverted
Zoom Mode
Record Length
Waveform Math or
FFT
Waveform Record
Slow-scan
Persist
Note: When the autoscale is turned on and running, the Autoset button is
invalid.
Description for icon:
Cancel Autoset： Go back to display the upper menu and waveform information.
Note: The Autoset function requires that the frequency of signal should be no
lower than 20Hz, and the amplitude should be no less than 5mv. Otherwise,
the Autoset function may be invalid.

Print the Screen Image

To print an image of what appears on the oscilloscope screen, do as the
follows:
(1) Connect the printer to the USB Device port on the side panel of the
oscilloscope.
Note: The USB Device port supports PictBridge compatible printers.
(2) Click to call up the menu panel. Click the Utility softkey on panel,
select Function in the bottom menu, select Output in the left menu.
(3) In the bottom menu, select Device as PICT. (When PC is selected, you
can get an image by Oscilloscope software.)
(4) In the bottom menu, select Print Set. In the right menu, set the print
4.Advanced User Guidebook
The previous source before autoseting.
When the previous source has no input signal, the
source will be set to the minimum channel which
has input signal.
When all the channels have no input signal, the
source will be set to CH1.
DC
Rising edge
3/5 of the Vpk-pk
Auto
YT
Stop
Exit
Off
Off
Exit
If greater than 10M, it will be set to 10M
Off
Off
Off
Off
94