Owon TAO3000 Series User Manual page 71

Operate
Storage: Save the current wave according to the start frame and end frame
set.
Storage menu shows as follows:
Menu Setting
Start frame
Storage
mode
Frame Set
End frame
Save
Load
To use wave record function, do as follows:
(1) Click to call up the menu panel. Click the Save softkey on panel.
(2) Select Type in the bottom menu, in the left menu, select Record.
(3) Select Mode in the bottom menu, select OFF in the right menu.
(4) In the bottom menu, select Storage as Internal.
(5) Select Mode in the bottom menu, select Record in the right menu.
(6) Select FrameSet in the bottom menu, set End frame and Interval in the
right menu.
(7) In the bottom menu, set Refresh.
(8) In the bottom menu, select Operate as Play.
(9) Select Mode in the bottom menu, select Playback in the right menu. Set
FrameSet and Playmode, select Operate as Play.
(10) To save the wave recorded, select Mode in the bottom menu, select
Storage in the right menu. Select FrameSet in the bottom menu to set the
range of frames to store, select Save in the bottom menu.
(11) To load the waveform from the internal memory, select Load in the bottom
menu, then enter the Playback of the Mode to analyze the wave.
Note: When playbacking the waveform, the sampling, trigger, or display
function is not available.
When storage medium is External, Wave Record contains two modes:
OFF, Record.
Record menu (External Storage) shows as follows:
Menu Setting
Mode
Record
Record
mode frame
4.Advanced User Guidebook
Play Begin to record
Stop Stop recording
Click
frame to store (1 - 1000)
Click
frame to store (1 - 1000)
Save the waveform record file to the internal
memory
Load the waveform record file from the memory
OFF Close wave record function
Set record menu
End Click
to record (1 – 900,000)
Instruction
or to select the number of start
or to select the number of end
Instruction
or to select the number of frames
65