Save And Recall A Waveform - Owon TAO3000 Dual-Channel Series User Manual

bandwidth. Only if the measured channel is in Edge mode of Single trigger
type, the counter can be enabled. The counter is displayed at the right bottom
of the screen.
Operation steps:
1. Click , click the Trig Menu softkey on panel, set the trigger type to
Single, set the trigger mode to Edge, select the signal source.
2. Click , click the Display softkey on panel.
3. Select Counter as ON or OFF in the bottom menu.

Save and Recall a Waveform

Click to call up the menu panel. Click the Save softkey on panel, you can
save the waveforms, configures, screen images, record or clone the waveform.
The description of the Save Function Menu is shown as the following table:
Function Menu
Type
When the type is Wave, the menu shows as following:
Type
Wave
Source
Object
Object
& Show
4.Advanced User Guidebook
Setting Description
Wave Choose the saving type.
Configure About the Record type, see
Image "Record/Playback Waveforms" on P62.
About the Clone type, see "Clone and
Record
Recall a waveform" on P66.
Clone
For internal storage, only BIN can be
Format
selected. For external storage, the
(Right menu)
format can be BIN, TXT or CSV.
CH1 Check the waveform to be saved. (If
CH2 certain
Math corresponding
(or MathFFT) disabled.)
Wave0 to Choose
Wave99 waveform is saved to or recall from.
55
channel is off,
menu item
the address which
the
will be
the